Snow Meister SL-1
5-1/4" Wide3-1/4" High
Mill Finish Cast Aluminum
Black E-Coat Primer Cast Aluminum
Finish Accepts Powder Coating
And Exterior Grade Paint
Painted Cast Aluminum
Berger E-Coating is a black primer with an extended shelf life that can be top coated by contractors with a wet or dry paint system. Berger strongly recommends this primer be top coated prior to installation.
No Penetration Of Roof Surface Required
Secured Without Glues Or Sealants
Utilize Custom Milled Stainless Steel Screws To Clamp Them Into Place
Easy Mechanical Installation In Any Season
For Standing Seam Metal Roofs
Use With Structural And Non-Structural Preformed And Architectural Metal Roof Systems
Installation
Symmetrically designed to rotate 180° to match seam lock orientation
The SL will fit single lock T seams up to 1" deep x .575"
A 3/16" hex bit will be needed for installation. Do not over tighten.
The recommended method for determining proper torque is to install one unit first
After tightening the setscrews, loosen and remove the unit, inspecting the indentations created in the seam to see that proper compression was obtained.
Placement should be determined by qualified design professional.
Related Products
|
|
|
| Corinth | Half Round | |
|
$675.00
|
$450.00
|
|
|
|
|
| Oxford | Snap Seam | |
|
$800.00
|
$4.25
|
|
Recommended products
|
|
|
| Apollo | Waterproof Heating Cable 240v | |
|
$1,450.00
|
$1,200.00
|
|
|
|
|
| 16" W-Valley | Tip For Use With Acetylene | |
|
$135.00
|
$16.00
|
|
